Template:Settings

Field	Dependencies	Description
Sensitivity	Not dependent on other arguments	ISO sensitivity Typical 'Sensitivity' Values : 'Film Speed' 1600-25600 ISO (6400-102,400 mono) for SC1, SC2, SC2+. 1,200 to 19,200 ISO For SC2X
Shutter	Not dependent on other arguments	Shutter speed (1/exposure time) of each frame. Use a higher shutter speed to allow a higher frame rate.
FrameRate	Always dependent on Shutter and conditionally dependent on Horizontal, Vertical if specified	Frames per second The higher the Frame Rate,the slower the motion.
Horizontal Vertical	Conditionally dependent on Frame rate if specified	Horizontal and Vertical resolution in pixels.
Duration	Always dependent on Frame rate, Horizontal and Vertical resolutions	Captured video duration, including pre and post trigger times
Pre-trigger	Not dependent on other arguments	Percentage of the saved video that occurred BEFORE the trigger event.
Save Mode	Not dependent on other arguments	Three Save Mode options available to select what happens after a video has been captured: Automatic capture then save, review before save, and Background save. Background save feature is available in software version 2.4 and later.
Shot Count	Always dependent on Frame rate, Horizontal and Vertical resolutions, Duration, and Save Mode	Shot Count is the number of shots you can take with these settings.The camera captures videos as triggered until the shot count is reached, then the captured videos can be reviewed or are automatically saved, depending on the Save Mode setting. Shot count is ignored when Save Mode is set to Background save.
Overclock	Only available on SC1/SC2+/SC2X Models. Not dependent on other arguments	Overclocking allow the sensor to operate faster than the maximum design speed. A selection of overclock amounts from 'Off' being operating within the CMOS sensor's documented capabilities, and clock rate increasing A, B, C, and D for higher levels of overclocking, ranging approximately 10% to 40% faster. As a rule of thumb, we have observed good results with overclock C.
Sub-sampling	Only available on SC1 Models Not dependent on other arguments	Skips every other pixel and and every other line when the resolution is 1/4 or smaller of the maximum resolution. This effectively allows you to get a larger field of view when the camera is configured at a lower resolution. Works well with monochrome cameras. Some color artifacts may be present when enabled on color cameras.